Nitotile GP Price in Bangladesh

Description

Nitotile GP Price in Bangladesh

Tropical grade ceramic tile adhesive.

Description:
Nitotile GP is a grey cementitious powder.

Uses:
Nitotile GP is a high-quality adhesive for the permanent fixing of ceramic tiles. It can also be used for fixing of
insulating and acoustic boards based on expanded polystyrene, etc. For use in submerged conditions NITOTILE UW should be used.

Advantages:

•  Tropical grade to suit middle east working conditions.
•  Good open wet time.
•  Good slip resistance.
•  High adhesive bond strength.

Standards Compliance:
Laboratory tests show Nitotile GP conforms to BS 5980:1980 as a type 1 tile adhesive.

Application instruction:
1. Surface Preparation
All surfaces must be sound and thoroughly clean before Nitotile GP is applied. All traces of grease or oil must be
removed with FOSROC CHEMICAL DEGREASER. All loose particles of mortar, old wallpaper. paint, etc., must be
physically removed.

2. Surfaces
Nitotile GP can be applied directly on concrete, cement screeds, cement or lime mortars. Special attention must be
given to new construction prior to commencing tiling. Tiles should not be placed on concrete or blockwork until all
shrinkage movement has taken place.

NOTE: Nitotile GP should not be used directly on gypsum or gypsum board substrates. Please contact your nearest FOSROC technical representative for advice.

3. Mixing
6.0 to 6.5 litres of water are required for each 25 kg sack of Nitotile GP. A slow speed drill fitted with a suitable mixing paddle is recommended. Add powder to water and mix until a uniform, lump-free consistency is achieved. After mixing the material should be allowed to stand for 5 -10minutes after which time it should be re-mixed. No further
water should be added.

NOTE: Use of chilled water in extreme temperatures will increase open time of Nitotile GP.

4. Application
Nitotile GP is spread on the substrate to a uniform thickness of 2-3 mm. This is then combed horizontally. Place tiles firmly into adhesive bed ensuring good contact with a twisting motion. Only apply to areas which can be tiled in the adhesive’s open wet time (up to 1 m2 at a time).

5. Joints
Ceramic tiles should never be fixed with tight joints. Leave a minimum space of 2 mm around every tile.

6. Finishing
Remove excess adhesive with a damp cloth before material has set. Joint grouting with Nitotile GP GROUT, may be
commenced 24 hours after tiles have been laid.

Yield:
25 kg bag of Nitotile GP when mixed with 6.25 litres water will yield approximately 18 litres.
Coverage:
When applied at a thickness of 2-3 mm, one bag will cover an area of 6-9 m2 This however will be dependent on the
conditions of the substrate and the type of tile used.
Packing:
Nitotile GP is supplied in 25 kg sacks.
Storage:
Nitotile GP must be stored in dry conditions.
Health and Safety:
Nitotile GP is cement based. Care should be taken to avoid inhalation of dust and contact with eyes.

Technical Service:
FOSROC provides a comprehensive technical advisory service supported by a team of field specialists.

Additional information
Nitotile GP is part of a range of FOSROC tile adhesives and grouts which include:

• NITOTILE UW –                                             Cementitious ceramic tile
  adhesive for use in totally
  submerged conditions.
•  NITOTILE Grout –                                         Cementitious grout for
  filling of tile joints.
• NITOTILE 489 –                                              Epoxy-based chemically
  resistant tile adhesive and
  grout.

Important note:
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard terms and conditions of sale, copies of which may be obtained on request. Whilst Fosroc endeavors to ensure that any advice, recommendation specific cation or information it may give is accurate and correct, it cannot, because it has no direct or
continuous control over where or how its products are applied, accept any liability either directly or indirectly arising from the use of its products whether or not in accordance with any advice, specific cation, recommendation or information given by it.