Conplast WL

Description

Product Description:

Integral waterproofing liquid admixture for concrete and mortar to minimize permeability and increase the waterproofing properties of concrete and cement sand mortars for critical applications like roof slabs and screeds, basements, external plastering, bathroom floors, water tanks, sumps, drains etc. Conplast WL Xtra is a dark brown liquid based on cement dispersion polymers which mixes readily with water and therefore disperses evenly. Conplast WL Xtra waterproofs by improving the quality of the concrete or mortar. It reduces the water demand for required workability and minimizes segregation and bleeding. Thus, it is more effigy client compared to traditional powder and conventional
integral waterproof ng compounds as its use results in two-fold improvement of concrete or mortar.

Feature and Benefi tsp:

• Advanced Technology: New generation molecule yields high performance concrete. Suitable for any grade of concrete including higher grades.
• Corrosion resistant: Meets the requirements of Japanese code JIS Z1535 (modify ed) fi rest of kinds in the integral waterproof ng range.
• High Strength: Due to better dispersion of cement particles and helps in the better degree of hydration yielding high strength compared to control.
• Cohesive Mix: Improves workability and cohesiveness of the concrete.
• Durability: Improves durability due to reduction in permeability of concrete and corrosion resistance of steel.

Application Instructions:

• Add cement & aggregates to concrete mixer as per the mix design, mix in dry state for 1 minutes.
• Start addition of 75–80% mixing water & mix for 2-3 minutes.
• Fosroc Complast WL Xtra is added as per the recomb- mended dosage into the remaining mixing / gauging water, then add to concrete mixer & mix for another 2 minutes.
• Place the concrete or apply plaster, as needed.
• Cure the applied mortar or concrete as per good construction practices or use Fosroc Concore curing compounds.

Packaging:
Conplast WL Xtra is supplied in 200ml, 1, 5, 10-, 20-, 50-, and 200-liter containers.

Dosage:

The Optimum dosage is 200ml for 50kg of cement.. Site trials shall be carried out to validate the optimum dosage.

Note: Mix using Conplast WL Xtra will require much less water than normal mix for the same workability. Water reduction may be as much as 10% or more. If the moisture content of the sand
or aggregate changes i.e., it becomes wetter or dryer, then the amount of water used must be reduced or increased to give the original workability.

Health and safety instructions:
Conplast WL Xtra is non-toxic. Any splashes on skin should be washed well with water. If contact with eyes occurs, it shall be washed well with plenty of water and medical advice sought immediately.

Technical support:
Fosroc provides a technical advisory service for onsite assistance and advice on admixture selection, evaluation trials and dispensing equipment. Technical data and guidance can be provided for admixtures and other products for use with fresh and hardened concrete.

Important note :
Fosroc products are guaranteed against defective materials and manufacture and are sold subject to its standard terms and conditions of sale, copies of which may be obtained on request. Whilst Fosroc
endeavors to ensure that any advice, recommendation, specific cation or information it may give is accurate and correct, it cannot, because it has no direct or continuous control over where or how its products are applied, accept any liability either directly or indirectly arising from the use of its products whether or not in accordance with any advice, specific cation, recommendation or information given by it.